Posted on

Achieve different brick bonds and patterns with Eurobrick cladding systems

We are sometimes asked whether our cladding systems are suitable for different brick bonds and patterns. Generally, most brick bonds and simple patterns are easy to replicate using our cladding systems. Whilst most do not require any adaptions to the backer panel, some will need bricks slips or whole bricks to be cut to size

Stretcher Bond

The most common bond is stretcher or half bond and this is the one you are most likely to have seen. This bond requires the least amount of cutting brick slips to size, using the whole length (the stretcher) of the slip. This bond is the quickest and easiest to install on our systems. Once plumb lines have been established, the bricks slips slot into place leaving a 10mm vertical joint. This bond can be made visually more interesting by having bands of different colour bricks or by inserting a soldier course (see below).

Header Bond

Header bond is similar to Stretcher bond but with the key difference that the short end of the brick (the header) is exposed. To achieve this, a standard brick slip needs to be cut to size. This has cost and time implications for the project. Please also bear in mind that not all slips are the same, for example it is possible to cut two headers from a brick slip from our Britannia brick slip Range, but a Classic Range brick slip with a tumbled edge cannot be cut into a header as it will leave a straight edge and lose its character. In this case, headers have to be specially cut from whole bricks.

English Bond

English Bond has alternating courses of stretcher and header brick slips. The header slips will have to be cut to size but the backer panel and installation method remains unchanged.

Flemish Bond

This bond has been used on a number of projects over the years. It is achieved by alternating stretcher and header brick slips in each course. As with English bond, this style necessitates brick slips being cut to size. The suitability of the brick type and lead times for cutting should be checked at the earliest opportunity.

Stack Bond

Simply stretcher slips “stacked” on top of each other. Although this can be a weak bond when constructed traditionally (and is usually reinforced), this is not a problem when installing with our cladding systems. The look is easily achieved without the associated downsides.

Monk Bond

Not so common in the UK, but this finish is achieved by using two stretchers and then a header in an alternating pattern in each brick course.

Soldier Courses

Our panel systems are designed for horizontal brick courses. But soldier courses are possible by cutting out the two unwanted ribs from the skin. The skin is manufactured from high impact polystyrene meaning that it can be cut using a craft knife. Before the bricks are fixed in the vertical position, the cut is sealed with construction adhesiv


It is also possible to create simple patterns such as diamond shapes using contrasting brick colours. Simple patterns usually do not require adaptation of the backer panel. A competent installer should not have difficulties incorporating simple patterns into the brickwork.
More complicated patterns such as herringbone require careful planning and should only be attempted by an experienced installer. For these more technically challenging patterns, we would normally suggest forgoing the backer panel and arranging the pattern directly onto a flat substrate. There are of course time and cost implications when incorporating a complicated pattern into the design, which should be taken into account when designing and planning your project.