Eurobrick stone slip samples

Stone slips

We offer a selection of Bradstone reconstructed stone slips, available in various colours and styles in mixed sizes which can be used for a whole project or to provide architectural detail.

We supply stone slips and corner pieces manufactured to order by Bradstone. The slips and corners are available in 3 heights; 65mm, 140mm and 215mm and can be ordered in mixed heights if required.

The slips and corners are supplied in a range of lengths as shown in the tables below. Please note it is not possible to specify a particular length.

Please contact us to discuss the desired coursing pattern and ratio mix of stone slips and to confirm current manufacturing lead times.

Stone slips can be applied directly or installed using one of our panel systems. Please see our stone installation instructions on our Brochures & general information page, where you may also download our Stone leaflet.

Rough Dressed Buff
Rough Dressed Southwold
Square Dressed Pennine
Rough Dressed Iron Ham
Square Dressed Buff
Traditional Buff

Traditional & Rough Dressed stone slips

Height (mm) Length
(mm)
Corner pieces return (mm)
65 190 215 240 265 290 315 100
140 190 215 240 265 290 315 100
215 240 327 100

 

Square Dressed stone slips

Height (mm) Length
(mm)
Corner pieces return (mm)
65 190 215 240 265 290 315 100
140 190 215 240 265 290 315 100
215 215 290 100

All dimensions are nominal and do not include an allowance for a joint, normally 10mm on height and length.

Thickness of stone is normally 20mm at edges but this increases to 30-35mm in the centre of pieces, depending on relief.

Other stone options

Other stone finishes not featured in our standard range can be supplied. Specific natural quarried stone types can be sourced as cut slips and other manufactured stone cladding options may be available. Please talk to one of our experts to find out more about other options available.

Important

It should be noted that as the materials used in the manufacture of stone products are from natural sources, variations in shade and dimension can occur. This should not be viewed as a fault in production and should be taken into account at the design stage of the project. Installers must carefully monitor all materials used and reject any sub-standard or unsuitable materials prior to installation. Eurobrick Systems Limited will not accept any liability for any costs arising from the rejection of materials once they have been installed. Samples are available upon request.